Home Decor Quotes Religious


Video instructions for vinyl application



Text Instructions:


Instructions For Application and Removal
The vinyl comes rolled up so it’s a good idea to lay it out flat before attempting to apply it. The tape over the  vinyl will be wrinkled but it does not effect the vinyl.Vinyl decals come as three layers: the white backing, the decal itself, and transfer tape.
1. Clean your destination surface. The cleaner the better.2. With your decal as-is (still taped up), lay your decal (backing-side down, transfer-tape-side up) and align as you like it. It should be adhesive side down, looking like it will look after applied. Once you get it lined up how you like it...3. Place a strip of masking-tape (vertically) down the center of the image to hold in place, over-lapping the edge onto the destination surface. Make sure the image won't move.4. Pull one side of the decal (the entire decal - transfer tape, backing and all) back flat against itself, folding over the masking-tape center-line that you just placed to hold it down. Don't crease it, just "bend" it or "fold" it.5. Using a sharp angle, start in a corner and peel away the decals backing (away from the transfer tape that is holding the vinyl image) until you get to the masking-tape-center-line you laid to hold it in place. Keeping the vinyl (on the application-tape) pinned back with your finger, cut away the removed backing along the center-placement-tape line. Careful not to scratch your surface or cut your vinyl image.6. Using any squeegee like item (a credit card works well), begin to lay your graphic down onto your prepared surface from the masking-take center line outward. DO NOT LAY DOWN ALL AT ONCE! Hold the image away from the wall, starting at the center-placement-tape-line. Squeegee from the center-tape-line outward as you lay it down. 7. Once one side is laid down, remove the center-tape-line, then remove the other half of the vinyl backing the same way as before, and repeat the process for the other side. 8. Squeegee the entire image a few times, from the center outward, each time with greater pressure, making sure that all of it is good and pressed onto the surface. 9. Once you feel it is pressed on as good as can be, begin peeling the transfer tape off using a sharp angle against itself. If the image comes off the surface (sticking to the transfer tape), simply lay back down, and squeegee as before, then try again  - remember, a sharp angle works best when separating vinyl from either the backing or the tape. If the decal does not stick, blow over the decal with a hair dry then try removing the tape again.                        
                                                                  Removal of the decal  
On a wall or painted surface, use a blow dryer to get the adhesive to loosen a bit, then peel it up.  If you do not heat it, it may take up some paint with it.  If there is any residue left behind, we use Goof Off.
Please contact us directly if you have
 any issues applying your vinyl or if there are any missing letters/mis-spellings and we will get the issues corrected right away!
Lewis and Genia Wheeler
Powered By OpenCart
Wheeler3Designs © 2021